Faxback AudioCodes Mediant 1000 - Configuration Guide Manual do Utilizador descarregar pdf (Página 5)

AudioCodes Mediant 1000 Conguration Guide — age 5

Trunk Groups

Conguration > Protocol Conguration > Trunk/IP Group > Trunk Group

e following screen shot is an example only, your hardware will need a dierent conguration. Read below for details. See also

“Media Gateway Conguration Examples” for sample congurations.

e conguration instructions that follow will use Trunk Group ID 1 for all “PSTN” ports. at is, all ports capable of calling

other numbers. Trunk Group ID 2 is used only for FXS ports that connect directly to fax machines.

Module: Choose one of the modules installed in the Mediant. You will repeat the following conguration for each module

installed in the Mediant chassis. Note that each individual port on each FXS device will need its own line as well if the port phone

numbers are non-consecutive. See the “Phone Number” entry below for more information.

From Trunk / To Trunk: PRI modules (only) require an additional “From Trunk” and “To Trunk” setting. Set “From Trunk”

to 1 and “To Trunk” to the highest number available.

Channels: is indicates the range of channels to include in this group line. For FXO modules, this will be “1-4”, for FXS it

can be either “1-4” as well, or it can be each individual channel.

Phone Number: is will be the default caller id when caller id could not be determined. For FXO and PRI modules you can

enter “1000” if it is the rst module, “2000” for the second module, etc. For FXS ports, you will need to enter either a real phone

number that will be associated with that port or assign a simple extension. If you are using real phone numbers and all the ports on

the FXS module will be sequential then you can create just one group entry for the entire module, the Mediant will automatically

add the port number to the Phone Number specied here.

Trunk Group ID: Assign all modules, trunks, and channels that will be connecting to the PSTN (i.e. FXO ports and PRIs) to

Trunk Group ID 1.

Assign all modules, trunks and channels that will be connecting to internal devices (i.e. FXS ports) to Trunk Group ID 2.

IP Prole ID: Proles are generally not needed. Set all IP Prole IDs to 0.

Click “Submit” when you are done. Click “Burn” at the top of the page.

1 2 3 4 5 6 7 8 9 10 11 12 13

Sem comentários

Faxback AudioCodes Mediant 1000 - Configuration Guide Manual do Utilizador Página 5