Faxback AudioCodes Mediant 1000 - Configuration Guide Manual do Utilizador descarregar pdf (Página 10)

AudioCodes Mediant 1000 Conguration Guide — age 10

FXO Conguration

Conguration > Protocol Conguration > Endpoint Settings > Automatic Dialing

NOTE: Do not congure automatic dialing for FXS ports; this will prevent you from faxing to any number but the

“Destination Phone Number.”

If you are receiving DTMF tones from a PBX on the FXO lines, it is not strictly necessary to congure automatic dialing. It is

recommended to congure automatic dialing so that the call is not lost if the PBX fails to send DTMF tones. For each FXO port,

enter the port’s corresponding phone number in the “Destination Phone Number” eld. Set “Auto Dial Status” to “Hotline.”

If you are not receiving DTMF tones, you will need to congure a xed phone number for each FXO port. Enter the port’s

corresponding phone number in the “Destination Phone Number” eld. Set “Auto Dial Status” to “Enable.”

Click “Submit” when you are done. Click “Burn” at the top of the page.

Conguration > Advanced Applications > FXO Settings

Dialing Mode One Stage

Conguration > Protocol Conguration > Protocol Denition > DTMF & Dialing

is controls DTMF collection on both FXO (inbound dial) and FXS (outbound dial) ports. If you are not using FXS ports,

and are doing DTMF collection on the FXO ports, then you can decrease the values here to slightly decrease call times.

For example, if you are collecting 4 digits on the FXO ports, try these timings:

Max Digits in Phone Num 4

Inter Digit Timeout for Overlap Dialing 1

Hotline Dial Tone Duration 2

Test after making any changes to verify all DTMF digits are still being captured.

Burn Conguration Changes

IMPORTA N T: Click the “Burn” button at the top of the page so that the conguration will be permanently saved to ash

memory. If you do not click “Burn,” any changes you made will be lost when the device reboots.

1 2 ... 5 6 7 8 9 10 11 12 13

Sem comentários

Faxback AudioCodes Mediant 1000 - Configuration Guide Manual do Utilizador Página 10